SA Prodigy

1911 Spring Guide. GI format spring guide with beveled head to prevent damage to lower lugs of barrel. Head geometry and dimensions are optimized for correct slide travel, even with common buffers installed. Heavily tumbled to remove sharp edges...

1911 Commander Spring Guide. GI format spring guide with beveled head to prevent damage to lower lugs of barrel. Heavily tumbled to remove sharp edges. Stainless steel, natural finish. Fits all 1911 Commander sized 1911s (4.25" barrel) and clones in all...

Our 1911/2011 Mainspring Housing (MSH) Pin Tool features a robust and compact all steel design with a punch long enough to reach all the way through a 2011 grip module to drive the MSH pin out, even on guns with mag wells installed. Also works perfectly...

Our 2011 Armorer Tool is the next step in our evolution of bench tools, and is designed to assist in the disassembly of a 9mm 1911/2011 slide.  The 9mm extractor's claw tends to overhang the breech face, making it a challenge to cleanly push it...

The Armorer Block is the culmination of years of tinkering on the 1911 and getting by with a box of tools and fixtures that didn't quite do what I wanted.   This 4"x4"x1.25" block is CNC machined from super tough nylon, and will give years of...

The 10-8 Performance Armorer Tool is a simple nonmarring tool molded from glass reinforced nylon. It is useful for countless applications where use of metal tools can easily damage your work. It is approximately 5" long and 1/4" in diameter, and features...

Our original 1911 hammers have been redesigned for even better performance! 10-8 bobbed spur hammer, tool steel with black oxide finish. Due to the short spur, this hammer will fit into most common beavertails where your existing hammer fits...

The 10-8 Performance magazine catch for the STI/Staccato 2011 Gen1 Grip Module features a unique 30lpi serrated curved button surface for positive activation. The curved button surface matches the contour of your thumb pad when the pistol is rolled over...

**For Springfield Emissary, and Prodigy models ONLY, which have a 4.25" CONE barrel and reverse plug which loads from the rear of the slide's spring tunnel.   **IF YOUR GUN HAS A BARREL BUSHING, THIS IS NOT FOR YOUR GUN!  You...

**For Springfield TRP Operator, Emissary, and Prodigy models ONLY, which have a 5" Government Model length CONE barrel and reverse plug which loads from the rear of the slide's spring tunnel.   **IF YOUR GUN HAS A BARREL BUSHING, THIS...

*While this part is a drop in fit in many pistols, gunsmith fitting may be required on some guns.  The .200" (nominal) diameter pin is typically bigger than your factory unit (they tend to run .195-.199") and may not fit into the frame hole...