Our second generation slide stop is an all original design that is totally reengineered to provide you a whole new level of functionality.
- Long wide pad for positive manipulation
- Interior of lobe angled for easy installation - no more scratches on your slide!
- Engagement surfaces optimized for positive lockback
- Geometry improves slingshot slide release during reloads
- Design improves detent spring pressure to minimize chance of premature lockback
- .200" (nominal dimension) pin for improved lockup
- Right end of pin has protruding convex domed tip, same as GI slide stops
Fits all 1911 pattern pistols, including Govt/Commander/Officer sizes and 2011/Caspian/Para double column frames.
.45 ACP version has .200" lobe protrusion.
9mm/.38/.40 version has .220" lobe protrusion. **All calibers other than .45 will use 9/.38 slide stop**
Machined from bar stock and heat treated.
Carbon steel version has black oxide finish.
Stainless Steel version has matte bead blast finish.
**While this part is a drop in fit in many pistols, gunsmith fitting may be required on some guns. The .200" (nominal) diameter pin may be bigger than your factory unit (they tend to run .198-.199") and may not drop right into the frame hole or may create a tighter lockup with the barrel's lower lugs.
***A popular question is "will this fit in my XXX 1911." As above, every single 1911 will be a little different, and may or may not require gunsmith fitting.
ReviewsMikeFits perfectly on my Springfield 1911 .45ACP. High quality part and much easier to press down than the stock slide release. Must have upgrade!Patrick Hannigan
Good designThis product was very well thought out all of the edges are cut at a radius so there’s Less chance of fracturing. There was enough material for me to cut the tab down a little bit. I don’t like things to extend out to far out on my pistolsGreg R
Outstanding productImproves look of pistol especially with the EGW thumb safety. Did require fitting to install but after 5 mins filing in the right spots it works flawless.
AmazingLooks great fits perfectly... matches the sti finish perfectlyJimmy Ward
Awesome Slide StopThis fit my Dan Wesson Vigil like a charm. Best company to deal with and their shipping rivals Amazon ;-)NS72
Quality replacement for MIM junkBought this part in hope of tightening the lockup on my S&W E series 1911. The stock part was .195 and really loose. The 10-8 stop is dead on .200, so I got .0025 tighter. Unfortunately, I still had a soggy lockup, and resorted to a slightly longer link to tighten it up and fix the 10-12" high impacts at 25 yds. A new barrel is in my future, I suppose.Ronald McCormack
Superb product that lives up to its advertisement.Replaced the MIM stop on my SIG two tone ultra carry. This fits perfectly and the SS color exactly duplicates the SIG SS. Installs easily and eliminates the problem with the idiot scratch. Forged parts far better than MIM. Finally, a product that works as advertised. I'll be back for more 10 8 parts.Jon L
100% perfectComparing to the OE MIM part is really unfair, as the 10-8 piece is in a whole different class. Perfectly machined, well finished and a perfect fit. An extra peace of mind and better "ledge" for activation too.C. Olson
Perfect drop in replacement.Perfect fit for my Kimber Ultra Carry II, well machined and the shelf matched my thumb safety perfectly.shane
Great product and designGreat design and works really good. Required a little fitting but for the most part drop in.
Leave a Review