1911

Disconnector for 1911. Machined from bar stock and black oxide finished.  The new Duty Tune 1911 line is composed of parts that are not unique 10-8 designs, but are solid OEM grade components that have been used in 10-8 builds over the years. We...

Our flat head grip screws are made to the original GI print, and have a concave slot profile to allow the use of a cartridge rim as a field expedient screwdriver.  Set of 4. Prehardened carbon steel bar stock with blued finish.  For standard...

Our flat head grip screws are made to the original GI print, and have a concave slot profile to allow the use of a cartridge rim as a field expedient screwdriver.  Set of 4. Prehardened 416 stainless bar stock with natural finish.  For...

Our original 1911 hammers have been redesigned for even better performance! 10-8 bobbed spur hammer, tool steel with black oxide finish. Due to the short spur, this hammer will fit into most common beavertails where your existing hammer fits...

The 10-8 Performance 1911 extended magazine catch features additional length of approximately .045" over a stock catch, and a unique 30lpi serrated curved button surface for positive activation. This magazine catch also features a number of other...

Plunger Tube for 1911. Machined from bar stock and black oxide finished.  The new Duty Tune 1911 line is composed of parts that are not unique 10-8 designs, but are solid OEM grade components that have been used in 10-8 builds over the years. We...

Plunger Tube for 1911. Machined from stainless bar stock and matte bead blast finished.  The new Duty Tune 1911 line is composed of parts that are not unique 10-8 designs, but are solid OEM grade components that have been used in 10-8 builds over...

Our classic concave spring plug. Plug end protrusion is .100" with plug length (minus protrusion) of 1.0".  Machined from stainless steel, natural finish. Fits Commander Models with 4.25" bushing barrels only. Please note that 1911's with shortened...

Our classic concave spring plug. Plug end protrusion is .100". Machined from stainless steel, natural finish. Fits all full sized 1911/Government Models with 5" bushing barrels.  

**For Springfield Emissary, and Prodigy models ONLY, which have a 4.25" CONE barrel and reverse plug which loads from the rear of the slide's spring tunnel.   **IF YOUR GUN HAS A BARREL BUSHING, THIS IS NOT FOR YOUR GUN!  You...

**For Springfield TRP Operator, Emissary, and Prodigy models ONLY, which have a 5" Government Model length CONE barrel and reverse plug which loads from the rear of the slide's spring tunnel.   **IF YOUR GUN HAS A BARREL BUSHING, THIS...

*While this part is a drop in fit in many pistols, gunsmith fitting may be required on some guns.  The .200" (nominal) diameter pin is typically bigger than your factory unit (they tend to run .195-.199") and may not fit into the frame hole...