Magazine Catch, Staccato 2011, Gen2 Double Stack

The 10-8 Performance magazine catch for the Staccato 2011 Gen2/3 grip modules features a unique 30lpi serrated curved button surface for positive activation. The curved button surface matches the contour of your thumb pad when the pistol is rolled over for a reload, and the serrations provide improved traction over the smooth factory unit. Overall length of the button protrusion, as measured at the longest part, is the same as the factory unit. This is NOT an extended length/width button. Face of the serrated button features a machined bevel to improve user comfort during handling and carry.

Fits ONLY Staccato 2011 double stack models with Gen2/3 grip modules (P, P DUO, XC, XL, C2, C2 DUO). Does NOT fit legacy grip modules, aftermarket metal grip modules, single stack models (legacy/discontinued C, C DUO, R). DOES NOT FIT STACCATO v3 guns such as the CS or 2024 C.

• Gen2/3 Grip Modules can be identified by the molded texturing and the star logo on the lower portion of the side of the grip.
• Gen1/Legacy Grip Modules may have the tree bark texturing or double diamond molded checkering, as well as the faux grip screw at the bottom half of the grip. This catch IS NOT compatible with these modules.

Machined from hardened 4140 bar stock, with black oxide (blue) finish. Magazine catch only.

Requires factory Staccato Gen2 mag catch lock, NOT INCLUDED (and not sold by the factory - use the one that's IN your Gen2 grip module).

If you're retrofitting your existing gun, you will be reusing the factory catch lock and spring.

These parts are made to the original STI/Staccato Gen2 mag catch factory spec, but due to variances in the molded grip module and production changes, this part may be a bit sticky in your grip module. Here are a few trouble shooting steps:

1. Ensure that the new mag catch (with no spring/catch lock) fits smoothly in the grip module.
2. Check that the mag catch spring tunnel is clean - use a toothpick or paper clip to clear the tunnel, and then a pipe cleaner or compressed air to finish up.