Black hard anodized CNC machined 6061 aluminum adapter allows you to mount your Blackhawk T Series holster to a Safariland QLS fork for integration into your existing duty belt and other accessories. Installation is simple and uses existing screws from the holster and QLS fork kit. Thickness: .220".
Installation instructions (see photo gallery):
- Remove 3 large Phillips head screws from back of Blackhawk belt hanger.
- Place adapter onto holster with 10-8 lettering facing away from holster.
- Install 3 Phillips head screws from holster. If you are OCD, 10 in/lbs is appropriate.
- Take the 1/2" screws from the QLS kit and screw the QLS fork onto the adapter. Again for the OCD types, 10 in/lbs is appropriate.
**Not compatible with hole spacing on Blackhawk Omnivore or SERPA holsters.
ReviewsChrisPrimarily run safariland products and as such qls is my go to. This interfaces perfectly with my L3D. It does increase stand off which is unavoidable as it’s an additional plate. This is a must if you are not going to switch over accessory mounting for Blackhawks factory offerings.Joe
Blackhawk-Safariland AdapterFor many this is the product they've been demanding. However it is important to note it makes the holster sit significantly higher than when mounted to the blackhawk belt mount and higher than a safariland on the mid-ride UBL. If you like this holster and want to keep it just below the belt you may want to use the longer UBL.
Leave a Review