Precision CNC machined from hardened 4140 tool steel and finished in black QPQ salt bath nitrocarburizing (aka Melonite, same as the Glock slide). Fits: ALL Glock models, all calibers, all frame sizes, all slide sizes, all generations to include...

*While this part is a drop in fit in many pistols, gunsmith fitting may be required on some guns.  The .200" (nominal) diameter pin is typically bigger than your factory unit (they tend to run .195-.199") and may not fit into the frame hole...

The Armorer Block is the culmination of years of tinkering on the 1911 and getting by with a box of tools and fixtures that didn't quite do what I wanted.   This 4"x4"x1.25" block is CNC machined from super tough nylon, and will give years of...

Tall rear sight for clearance over slide mounted mini red dot sights (RMR, SRO, Holosun, and similar deck height. Does NOT cowitness over DeltaPoint Pro) or suppressors.  Fits Glock dovetail, profile will clear MOS cover/adapter plate.  CNC...

Extra tall front sights allow clearance over optics and suppressors. Blade is .125" wide with 40lpi serrations to provide crisp visual focus and glare reduction.  Finished in black QPQ salt bath nitrocarburizing (aka Melonite, same as the Glock...

These base pads are injection molded from glass reinforced nylon, and they are super tough and resistant to impact.  Our pads fit and install the same as the factory floor plates, use the factory retainer plate (magazine insert), and no extra parts...

Features a solid aluminum shoe with a serrated face in bead blasted natural finish, a full width stainless steel bow, and a fixed stainless steel overtravel stop permanently mounted from the rear of the shoe. This trigger eliminates all issues associated...

1911 Spring Guide. GI format spring guide with beveled head to prevent damage to lower lugs of barrel. Head geometry and dimensions are optimized for correct slide travel, even with common buffers installed. Heavily tumbled to remove sharp edges...

Our classic concave spring plug. Plug end protrusion is .100". Machined from stainless steel, natural finish. Fits all full sized 1911/Government Models with 5" bushing barrels.  

Our flat head grip screws are made to the original GI print, and have a concave slot profile to allow the use of a cartridge rim as a field expedient screwdriver.  Set of 4. Prehardened 416 stainless bar stock with natural finish.  For...

Our Low Profile Glock Rear Sight features:  Scooped shoulders for improved downrange awareness Deep .125" notch Wider dovetail base for better fit in various generations of Glocks and aftermarket slides Serrated front face for better traction...

Our 2011 Armorer Tool is the next step in our evolution of bench tools, and is designed to assist in the disassembly of a 9mm 1911/2011 slide.  The 9mm extractor's claw tends to overhang the breech face, making it a challenge to cleanly push it...